Sunday, October 13, 2019
Platelet Rich Plasma-platelet Concentrate (PRP-PC) Analysis
Platelet Rich Plasma-platelet Concentrate (PRP-PC) Analysis Quality assessment of platelet concentrates prepared at Dr. Pinnameneni Institute of Medical Sciences and Research Foundation Dr. Anusha A.M Background Platelet rich plasma-platelet concentrate (PRP-PC) were prepared and their quality variables were evaluated. Material and methods In this study platelet products were prepared using platelet rich plasma method. After preparation the products were transferred to platelet incubator and agitated. Their quality was assessed after 24 hours of preparation using the following parameters: volume of the platelet concentrate, platelet count, RBC contamination, morphology and pH. Results Volume 90% of the RDP was weighing between 50 to 70 ml, 4% below 50 and 6% above 70 ml. The count correlated well in both the methods and 85% of RDP had a count of above 5.5 x 1010, 15% had below 5 x 1010. Ph: 56% of the RDP had of 6.3 to 6.5, 33% had 6.6 to 7.0 and 6% at 6.2 and 5% above 7.0. Appearance: 86% was light straw colored, 3% light pint, 6% pink and 5% red. Conclusion During the storage of platelet concentrates there is progressive loss in capacity of survival and function of platelets. In order to maximize the preservation of platelet viability it is best to allow PRP to repose at room temperature for 1-2 hours and then transfuse as soon as possible. To maximize the therapeutic values of platelet concentrates quality control is essential and helps to identify trouble shooting in procedures. In conclusion more than 95% of the RDPs prepared meet the standard. Keywords:Platelet rich plasma-platelet concentrate, quality parameters, platelet count Introduction Transfusion medicine has over the years evolved to assume a complex medical discipline that aided or modified patient care. Blood donation culture has not been fully imbibed in our society and homologous blood is usually in short supply in the blood banks with its attendant consequences in patient management1. Platelet transfusion therapy has played an important role in the management of patients 2,3]. Today, platelet concentrates are prepared from whole blood either by differential centrifugation buffy coat-derived platelet concentrates (BC) or by platelet rich plasma- platelet concentrates (PRP-PC) and plateletpheresis (4,5). There are several methods for quality control of platelet components including cell counting, pH, volume and morphology.[6.7.8]. The aim of this study was to evaluate the quality of platelets during the storage of platelet concentrates derived from PRP-PCs and whether patients got adequate therapeutically useful amount of platelets. Materials and Methods The present study was conducted at blood bank, PSIMS RF, Andhra Pradesh, India. The study was carried out on 100 patients. Platelet products were prepared from whole blood using platelet rich plasma method. After preparation these were stored in platelet incubator and agitated. Their quality was assessed after 24 hours of preparation using the following parameters: volume of the platelet concentrate, platelet count, RBC contamination, morphology and pH. For the study, samples were taken from the segment of tubing in the platelet concentrate bag to maintain sterility inside the bag. Volume The volume of the platelet concentrates were measured by deducting the volume of the empty bag from the volume of the platelets concentrate bag in ml. The measurements were recorded. pH p H of the platelet concentrate units were checked by the use of semi-quantitative dipsticks ( Bayers multistix strips) Total Platelet Count Platelet count was done by 2 methods Automated method by using fully automated analyzer Sysmex KX-21 to assess the quality o the platelets. Counting was based on impedance technology. Manual method using counting chamber. RBC contamination Platelet concentrate unit was checked by visual inspection or various colours. Morphology Morphology was analyzed by staining smear by leishman stain. Results 1. Volume 95% of PRP-PC was weighing between 55 to 75 ml and 5% below 55. pH 76% of the PRP-PC had of 6.3 to 6.5, 20% had 6.6 to 7.0 and 4% below 6.3. Total Platelet Count The count correlated well in both the methods and 90% of PRP-PC had a count of above 5.0 x 1010 and 10% below 5 x 1010. 4. RBC contamination 92% was light straw colored, 4% light pint and 4% pink. Morphology 94% of the platelets were discoid, 4% spherical and 1% fragmented. Discussion The potential of transfused platelets to circulate and function is dependent on ex-vivo and in-vivo factors. The percentage of platelets that maintain discoid form is a primary and simple indicator for the quality of the stored platelet concentrates. PCs been gently prepared and then immediately transfused without a storage interval have high retrieval, good survival and conserved function. Quality assessment of platelet concentrates is an important step to evaluateex-vivofunctional viability of platelet concentrates and post transfusion recovery and survival in donee. Various variables are used for routinequality assessment of platelet concentrates such as volume, platelet count, morphology, RBC contamination and pH. Conclusion During storage, platelet concentrates gradually lose the capacity to survive and function. In order to preserve platelet viability, PRP should be allowed to rest at room temperature, for 1-2 hours and transfused as soon as possible thereafter. There is a need to improve the quality of the platelet concentrates being prepared to get maximum therapeutic values. Doing quality control is essential and it is not only valuable in itself but also helps in identify trouble shooting of the procedures. In conclusion more than 95% of the PRP-PC prepared met the standards. References Olaitan PB, Onah I I, Ogbonnaya I S. Preliminary reports of autologous blood transfusion in a plastic surgery unit. Tropical Doctor.2006; 36: 20-21 Snyder EL, Hezzey A, Katz AJ, Bock J (1981) Occurrence of the release reaction during preparation and storage of platelet concentrates. Vox Sang 41:172-177. Heaton WA, Rebulla P, Pappalettera M, Dzik WH (1997) A comparative analysis of different methods for routine blood component preparation. Transfus MedRev 11:116-129. Fijnheer R, Pietersz RN, de Korte D, Gouwerok CW, Dekker WJ, et al. (1990)Platelet activation during preparation of Platelet Concentrate: A comparison of Platelet Rich Plasma and the buffy coat methods. Transfusion 30: 634-638. Jerad S, Prane K (1997) The Platelet Storage lesions. Transfusion Medicine Reviews 2: 130-144. Dijkstra-Tiekstra MJ, Pietersz RN, Huijgens PC (2004) Correlation Between the extent of platelet activation in platelet concentrates and in vitro and in vivo parameters. Vox Sang 87: 257-263. Kamath S, Blann AD, Lip GY (2001) Platelet activation: assessment andquantification. Eur Heart J 22: 1561ââ¬â1571. Albanyan AM, Murphy MF, Rasmussen JT, Heegaard CW, Harrison P (2009)Measurement of phosphatidylserine exposure during storage of platelet concentrates using the novel probe lactadherin: a comparison study with annexin V. Transfusion 49: 99-107. Rinder HM, Smith BR. In vitro evaluation of stored platelets: Is there hope for predicting post-transfusion platelet survival and function?Transfusion.2003;43:2ââ¬â6 Holme S. Storage and quality assessment of platelets.Vox Sang.1998;74:207ââ¬â16.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment